Mouldings and Trims
The CD2 is designed to thoroughly and uniformly finish sand and sealer sand work pieces such as moldings, trim, flooring, etc. Use it to sand moldings and enjoy uniform quality regardless of job. A uniform sanding of moldings gives you a consistent stain color when it comes time to finish your moldings.
The QuickWood CD2 Series Molding sanders have two or more horizontal top spindles and can have two or more vertical side spindles plus two or more horizontal bottom spindles to sand various surfaces.
All spindles are adjustable for different product sizes as well as abrasive wear. The top and side spindles are tiltable for optimum sanding.
Full width pressure rollers easily adjust by hand crank to hold the work pieces firmly on the power roller conveyor and against the guide fence.
This configuration is the perfect fit molding sander for medium to small operation. These machines have it all!
It has variable speed on the driven rollers, 10-50 feet per minute.
It has 4 hold-down pressure rollers from the top which hold the molding firmly in place while traveling though the machine.
Each spindle has variable speed to change the sanding on the molding for less sanding in sealer and primer coats to more sanding on raw wood.
These machines will remove light knife marks and prep the wood for staining and sealing without harming the profiles and contours of your work.
The initial pre-sand is very important to the molding, as consistency in the stain color comes from this pre-sand. The pre-sand is a uniform sanding of the top surface of the whole molding using pairs of counter rotating sanding spindles.
Brush sanding moldings and trims
Achieve uniform stain color on both the top and the bottom of the molding with a QuickWood CDU2+2+2. When the sealer coat is applied to the molding, pre-sanding with the QuickWood molding sander smooths and removes sharp edges.
This does not mean that the brush sanding distorts the profile. It only means that knife sharp edges are dulled to allow the stain and sealer to adhere to the edges without bleeding away and causing yellow lining. Sharp edges prevent stain absorption which is why it is critical to smooth those edges.
To make the edges as strong as possible a light break is given to the raw wood, so the stain and sealer coats adheres better on the edges.
After stain and sealer has been applied and the molding has dried the QuickWood brush sander is now ready for sealer sanding on the molding. Simply reverse the spindle rotation and use QuickWood’s Quick-Strip Double Sided Abrasive.
The Quick-Strip Double Sided Abrasive can accept whatever grit you want to use on the heads. Changing between the two grits is as simple as flipping a switch.
The sander can be setup with 150 grit for pre sanding and 220 grit for sealer sanding.
Any grit from 60 to 600 is available for the machine.
Special sanding applications like the Rustic look (Weathered), Antique look (Distressed) or South Western look (Sandblasted) can be achieved by using steel brushes or stiff tynex brushes.
The basic CD2-300 molding sanding machine comes with 2 top heads, made with variable speed to change the aggressiveness of the sanding on the molding. This is simply the best machine for sanding moldings
QuickWood has more than 200 automatic machines in the USA for sanding moldings and trims. It’s time for you to make this vital tool part of your collection.